A, Suggestions on the entry conveyor increase detection device

Common is the use of weighing machine test weight, once had 5% of the rated weight, changchun automated multi-layered storehouse manufacturer then not allowed into automated stereoscopic warehouse, implementation means there are two ways:

1, electronic control;

2, the control system software, once the induction to the tray is overweight, were not allowed to release, probably don't even allow registration of pallet.

Control system software is proposed, changchun automated stereoscopic warehouse factory mainly because more simple and flexible software control, low cost, and can expand some function. In addition, the automated multi-layered storehouse for fine control, such as scheduling stacking of motor, the weight of the goods to the stacker, let the stacker automatically adjust the frequency converter parameters according to the weight out of higher cost performance (the balance of speed and power consumption) start braking curve.

Second, in the entrance on the conveyor motor corresponding to the frequency converter set

Such as lowering the torsional moment of the larger threshold, once overweight will alarm and stop. This parameter can be through the communication protocol is open to the corresponding system, may need to set different parameters for different entrance, so that you can judge for flexible; Or change a point of view, automated stereoscopic warehouse storage conveyor running, PLC, frequency converter remove torque parameters is open to information system, the system according to the weight of the goods in advance and motor output torque relations, curve plotting function relation, so every time according to the torque value, can estimate weight, once overweight, by the system alarm and stop indicate current lose data.