1, if the manual handling operation, status is greater than the distance between the location of the width of the large packing + Z 20 cm;

2, if need to put the pallet at the bottom of the location, the upper is manual handling, the distance between the location for the "manual forklift and pallet" turning diameter + 20 cm;

3, if the location requires electric forklift truck carrying, the distance between the location of "electric forklift + above pallet"; turning diameter + turn insurance distance;

4, generally if you have a forklift, to look at the models of forklift, if is a large domestic forklift truck that is about 4 meters; If it is a small fork lift truck or only hydraulic trailer that 2.5 m ~ 3 m will be enough.

Specific calculation formula is: aisle = small turning radius + forklift forklift Z before hanging from the fork (front wheel center the arrival of the plane distance) length + + goods safe distance (about 20 cm).

It's worth noting that there is a wall, wall is apart from the mean is the span between the shelf and wall, the wall of the warehouse planning generally reserved is from 10 to 30 cm, obligate wall spacing for two reasons: one is moistureproof, because some

Walls will ooze water, when it rains or along the walls of the water; Two is convenient pass in and out, for example use card board loaning or large goods, with the pickup of the truck, too close to the wall, it is difficult to take goods.

Beijing heavy shelves when using the matters needing attention

Heavy shelves in the place such as factories, are common, so when use, should pay attention to what? Under the heavy shelves this time is very important!

1, prevent overload

Heavy shelves while bearing ability, but also cannot exceed a certain range, can't more than the weight of the each layer stacking shelves of Z big capacity, so as not to cause collapse danger, at the same time, the heavy shelves to place the goods also must pay attention to the top put light, when the underlying put heavy, but also on the premise of not overload.

2, prevent collision

At work in the process of operation, to keep the ground flat, light to take light put, prevent loss of shelf impact at the same time, to be on the safe side, goods shelves above, good staff Z don't directly into the bottom shelf.

3, the size of the measure

Shelves if more than 8 meters high, the need to have the corresponding removal device, so you should have enough work area, to adjust the height according to the size of the goods at the same time, improve work efficiency.

Is heavy shelves above the matters needing attention when using, must pay more attention in daily use, so as to ensure better use.

官网(wang)：//www.hzliben.cn